Nearby Plumbers Belmont, WI

He was modest and professional. He felt he did a good job. Replace the kitchen faucet.

It was the adventurous work that is progressing several times and not good at other times. The reason for the low classification (1) is the lack of insulation around the cold and hot water pipes in the very hot attic and (2) clouds from the expired dust, both of which are shown below. Many pictures are attached. In May 2018, we got rid of the Kitech Hot and Cold Water, which was installed by Builder (17 years ago), and we have installed new and hot hot water lines from PEX all over the house. The work is presented quickly and the tubes were completed in less than three days. Finland took two days, so everyone was completed within 5 days (from Monday to Friday). Problems: 1. He said that the hot and cold attic was not touched, but only put the value foam tube R3 on the lines, and there were distances through which you can see the red (hot) and blue (cold) holes. HaI .., the R-3 tube has not been properly closed and PEX was unable to surround most places. In some places, abandoned the isolation of PEX and did not pull the original isolation. See the attached pictures. 2. Sufficiently insufficient attic from the warm and cold PEX, which leads to isolation, cold and cold water temperatures can be about 15 degrees above the external environment. This is not a summer problem in summer, but there is a problem with the cold side. For example, on the distinguished days of our 100 degrees, the cold water temperature, 115 degrees was measured in 4 minutes. If you reach more than 110 outputs (which is what it does here), then the hot/cold water at the points of sale is dangerous. 3. Your pipeline and your final work are not coordinated on plaster panels. After the pipeline is finished, all plastic in the furniture (Wednesday) was canceled. Finland from the dust cloud floor, blind, furniture, everything, later (Friday). More debate: • At the beginning of the work (Monday in the morning), the floor was covered with paper and insurance, and all furniture were covered with plastic. Our connection, Killin, was very useful for organizing everything. • The work continued without a problem, and when the tube was completed and the holes (but no plaster) were covered, all plastic paper and protection were removed. • While testing the system, the only problem was the cold cross to heat the lounge of the external saliva. It was resolved soon. • Fixing plaster panels started with filling, spraying and texture on Thursday. He did not put anything in a small amount of blankets and furniture. • After drying the texture, an electric sanding reduces the surface, causing a cloud of dust covering everything at home. He said he used the HEPA candidate vacuum, but it was not effective with a cloud of dust. • After finishing the paint, we took a whole day to clean the dust. Why will the original plastic cover be preserved until all the work ends? • When the mirrors are repeated, we noticed that one tears, and put it on the floor of the tiles without filling. We receive $ 150 to change it. • Well, we saw that cold water was hot. SACRARARENTO re -installed the Gundfos recycling system. It was not expensive, but in fact a stupid system, every time there is no water in the pump and the local sensor (found in the tap), the atmosphere is very hot to push the cold water line (and return to the hot water tank). Feeling filters, so when the pump is closed, hot water still passes to the cold water line. We cut the local sensor and worked on quiet days. • However, the main problem is that hot and cold water lines in the attic were not properly isolated. The gentle foam tubes have a rating of about 3, and the bad installation of foam pipes is made in hot and cold water lines (not properly closed). They did nothing to keep the tongue insulation, so drought isolating almost closed in some areas. See the attached picture. At a standard temperature of 115 degrees in the open air (our), cold water will be extended. This is definitely a problem with the water and food system for refrigerator water. • We plan to make a trainee or a repairing company to repair everything (the estimated cost is $ 1,200). Repeat that people do not know anything except plumbing, as Lincolns inspectors (who are currently looking for problems in the heat -related pipelines). Conclusions: Cold and cold water lines failed properly to isolate themselves, leading to a possible serious situation. Cold water provisions are exposed to the temperature of the attic, which can easily cause water in the taps, toilets and refrigerators in inputs more than 120 degrees. Imagine to enter a shower with a workshop with more than 120 water and the water temperature cannot be rejected. In winter, with a cold temperature of 17 degrees ....? They fell and washed the isolation fly in many areas and did not replace it. He raised the A/C cooling line in some places. I was in a hurry with all his works in the attic. This is unacceptable and call. Your answer: without an answer. Change Pex Kitech with a new PEX

Everything was good. He has a place F.W. Through the Webb store, we requested the toilet form that we wanted. There was an agreement with him as he got a professional discount, which went completely to us, imposing only time fees. Soon we got an appointment with him and he was restricted and visible to time. They did not charge us until all the work was completed, even if they asked for the bathroom. Fix toilet

We bought a new fau. The plumber was clean and professionals and served quickly. Frozen/frozen pump tube has changed.